摘  要：本文介紹了一種基于以太網接口的3D打印機控制系統，采用ARM嵌入式處理器與FPGA相結合的設計方案，并采用SMSC公司的網絡芯片LAN8720A，實現打印機系統的網絡功能。給出了系統的結構圖，網絡硬件電路圖以及網絡應用程序的編寫。 關鍵字：以太網  3D打印機　ARM　FPGA Abstract: This paper introduces a 3D printer control system based on Ethernet interface.The design scheme of the system is based on ARM embedded processor and FPGA, And the use of SMSC chip LAN8720A, to achieve the network function[登陸后可查看全文]